Email this article Local Physicomechanical Properties of Materials for Use in Calibration of Nanoindentation Instruments
- Authors: Golovin Y.I.1, Tyurin A.I.1, Aslanyan E.G.2, Pirozhkova T.S.1, Vorob’ev M.O.1
-
Affiliations:
- Nanotechnologies and Nanomaterials Education and Research Center, Tambov State University
- All-Russia Research Institute of Physicotechnical and Radio Measurements (VNIIFTRI)
- Issue: Vol 59, No 9 (2016)
- Pages: 911-915
- Section: Article
- URL: https://bakhtiniada.ru/0543-1972/article/view/245485
- DOI: https://doi.org/10.1007/s11018-016-1066-2
- ID: 245485
Cite item
Open Access
Access granted
Subscription Access
Abstract
Studies of variations in the hardness of representative materials of different classes over broad ranges of loads and depths of indentation are carried out. The usability of these materials is demonstrated and boundaries on the ranges of use of hardness meters produced from these materials for calibration of nanoindentation instruments are established.
About the authors
Yu. I. Golovin
Nanotechnologies and Nanomaterials Education and Research Center, Tambov State University
Author for correspondence.
Email: golovin@tsu.tmb.ru
Russian Federation, Tambov
A. I. Tyurin
Nanotechnologies and Nanomaterials Education and Research Center, Tambov State University
Email: golovin@tsu.tmb.ru
Russian Federation, Tambov
E. G. Aslanyan
All-Russia Research Institute of Physicotechnical and Radio Measurements (VNIIFTRI)
Email: golovin@tsu.tmb.ru
Russian Federation, Mendeleevo, Moscow District
T. S. Pirozhkova
Nanotechnologies and Nanomaterials Education and Research Center, Tambov State University
Email: golovin@tsu.tmb.ru
Russian Federation, Tambov
M. O. Vorob’ev
Nanotechnologies and Nanomaterials Education and Research Center, Tambov State University
Email: golovin@tsu.tmb.ru
Russian Federation, Tambov
Supplementary files
