Electrostimulated plasticity of titanium under tension
- Авторлар: Korolkov O.E.1, Misochenko A.A.1, Stolyarov V.V.1
-
Мекемелер:
- Mechanical Engineering Research Institute of RAS
- Шығарылым: № 16 (2024)
- Беттер: 658-669
- Бөлім: Physical and chemical foundations of nanotechnology
- URL: https://bakhtiniada.ru/2226-4442/article/view/319468
- DOI: https://doi.org/10.26456/pcascnn/2024.16.658
- EDN: https://elibrary.ru/KLZBIN
- ID: 319468
Дәйексөз келтіру
Толық мәтін
Аннотация
The paper confirms the possibility of electrical stimulation of plasticity, previously discovered in ultrafine-grained titanium. The regimes of pulsed current during tension have been experimentally determined, which make it possible to significantly increase the elongation to failure in commercially pure coarse-grained titanium Grade 4. It is shown that the introduction of single current pulses with an amplitude density of 300-400 A/mm2 with a variable duration from 100 to 1000 μs and a duty cycle from 1000 to 10000 during tension helps to reduce the ultimate tensile strength from 845 to 750 MPa and simultaneously increase the elongation from 10 to 21%. Structural studies using optical microscopy have shown that tension accompanied current does not affect the average grain size, but leads to reducing large particles and a partial dissolution of small inclusions. The results of structural studies, temperature measurements and features of deformation behavior when the current is turned off confirm the predominantly athermal nature of the increase in plasticity.
Негізгі сөздер
Авторлар туралы
Oleg Korolkov
Mechanical Engineering Research Institute of RAS
Email: korolkov_oleg@vk.com
Researcher
Anna Misochenko
Mechanical Engineering Research Institute of RASPhD, Senior Researcher
Vladimir Stolyarov
Mechanical Engineering Research Institute of RASDr. Sc., Chief Researcher
Әдебиет тізімі
- Илларионов, А.Г. Технологические и эксплуатационные свойства титановых сплавов / А.Г. Илларионов, А.А. Попов. - Екатеринбург: Изд-во Урал. фед. ун-та, 2014. - 137 с.
- Stolyarov, V. A pulsed current application to the deformation processing of materials / V. Stolyarov, A. Misochenko // Materials. - 2023. - V. 16. - I. 18. - Art. № 6270. - 20 p. doi: 10.3390/ma16186270.
- Wang, R. Design high-performance AZ31 ultrathin strip through multi-pass electroplastic rolling without off-line annealing / R. Wang, Z. Xu, Y. Jiang et al. // Materials Science and Engineering: A. - 2022. - V. 862. - Art. № 144510. - 8 p. doi: 10.1016/j.msea.2022.144510.
- Ghiotti, A. Electroplastic effect on AA1050 aluminium alloy formability / A. Ghiotti, S. Bruschi, E. Simonetto et al. // CIRP Annals. - 2018. - V. 67. - I. 1. - P. 289-292. doi: 10.1016/j.cirp.2018.04.054.
- Корольков, О.Е. Исследование и применение электрического тока для медицинских имплантатов / О.Е. Корольков, В. В. Столяров // Проблемы машиностроения и надежности машин. - 2021. - № 6. - С. 96-104. doi: 10.31857/S0235711921060122.
- Корольков, О.Е. Электропластический эффект в титановых сплавах при их растяжении / О.Е. Корольков, М. А. Пахомов, В. В. Столяров // Заводская лаборатория. Диагностика материалов. - 2022. - Т. 88. - № 10. - С. 73-82. doi: 10.26896/1028-6861-2022-88-10-73-82.
- Stolyarov, V.V. Atypical hardening caused by current and plastic deformation / V.V. Stolyarov // Journal of Machinery Manufacture and Reliability. - 2024. - V. 53. - I. 3. - P. 212-217. doi: 10.1134/S1052618824700080.
- Eipert, I. Improvement in ductility in commercially pure titanium alloys by stress relaxation at room temperature / I. Eipert, G. Sivaswamy, R. Bhattacharya et al. // Key Engineering Materials. - 2014. - V. 611-612. - P. 92-98. doi: 10.4028/
- Корольков, О.Е. Релаксация напряжений при растяжении, сопровождаемом током в ультрамелкозернистом титане / О.Е. Корольков, В.В. Столяров // Физико-химические аспекты изучения кластеров, наноструктур и наноматериалов. - 2023. - Вып. 15. - С. 135-147. doi: 10.26456/pcascnn/2023.15.135.
- Herbst, S. Electroplasticity Mechanisms in hcp Materials / S. Herbst, E. Karsten, G. Gerstein et al. // Advanced Engineering Materials. - 2023. - V. 25. - Art. № 2201912. - 12 p. doi: 10.1002/adem.202201912.
- Tang, Y. Microstructural modification and mechanical improvement of ultrafine-grained Ti alloy through electron wind force: An innovative approach / Y. Tang, Y. Ju, S. Gu et al. // Materials Science and Engineering: A. - 2024. - V. 891. - Art. № 145845. - 10 p. doi: 10.1016/j.msea.2023.145845
- Sheng, Y. Application of high-density electropulsing to improve the performance of metallic materials: mechanisms, microstructure and properties / Y. Sheng, Y. Hua, X. Wang et al. // Materials. - 2018. - V. 11. - I. 2. - Art. № 185. - 25 p. doi: 10.3390/ma11020185.
- Jiang, B. Numerical simulation and experiment of electrically-assisted incremental forming of thin TC4 titanium alloy sheet / B. Jiang, W. Yang, Z. Zhang et al. // Materials. - 2020. - V. 13. - I. 6. - Art. № 1335. - 8 p. doi: 10.3390/ma13061335.
- Ao, D.-W. Hot tensile behaviors and microstructure evolution of Ti-6Al-4V titanium alloy under electropulsing / D.-W. Ao, X.-R. Chu, S.-X. Lin et al. // Acta Metallurgica Sinica (English Letters). - 2018. - V. 31. - I. 12. - P. 1287-1296. doi: 10.1007/s40195-018-0735-3.
- Резяпова, Л.Р. Исследование выделений вторых фаз в наноструктурном технически чистом титане / Л.Р. Резяпова, Р.Р. Валиев, В.Д. Ситдиков, Р.З. Валиев // Письма о материалах. - 2021. - Т. 11. - № 3. - С. 345-350. doi: 10.22226/2410-3535-2021-3-345-350.
- Столбоушкина, О.А. Особенности формирования дислокационной субструктуры при ползучести алюминия в условиях приложенного потенциала / О.А. Столбоушкина, С.В. Коновалов, Ю.Ф. Иванов, В.Е. Громов // Перспективные материалы. - 2011. - №1. - C. 47-52.
Қосымша файлдар
