Enviar artigo por via de e-mail Mechanoactivated SHS of Si–SiC Powders from Natural Sand: Influence of Milling Time
- Autores: Chanadee T.1,2, Singsarothai S.3
-
Afiliações:
- Department of Materials Science and Technology, Faculty of Science
- Ceramic and Composite Materials Engineering Research Group (CMERG), Center of Excellence in Materials Engineering (CEME)
- Faculty of Engineering
- Edição: Volume 27, Nº 2 (2018)
- Páginas: 85-88
- Seção: Article
- URL: https://bakhtiniada.ru/1061-3862/article/view/195927
- DOI: https://doi.org/10.3103/S1061386218020061
- ID: 195927
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
Si–SiC composite powders were SHS-produced from milled ‘natural sand–C–Mg’ precursors under pressure of Ar gas; and the effect of milling time τ on the morphology and phase composition of combustion product was investigated. The reduction in particle size of sand with increasing τ was extremely significant for the formation of Si–SiC composite powders due to an increase in the surface area of contact. Smaller sand particles yielded finer Si–SiC powders.
Palavras-chave
Sobre autores
T. Chanadee
Department of Materials Science and Technology, Faculty of Science; Ceramic and Composite Materials Engineering Research Group (CMERG), Center of Excellence in Materials Engineering (CEME)
Autor responsável pela correspondência
Email: tawat.ch@psu.ac.th
Tailândia, Hat Yai, Songkhla; Hat Yai, Songkhla
S. Singsarothai
Faculty of Engineering
Email: tawat.ch@psu.ac.th
Tailândia, Papayom, Pattalung
Arquivos suplementares
